TRIGGER SHEATH - SPRINGFIELD HELLCAT PRO

Stop dressing ‘around’ your holster – wear the clothes you want while comfortably and securely carrying your concealed Springfield HELLCAT Pistol.
Clips to your waistband (with or without belt), boot, pocket, vest and more – with confidence.
Clipdraw is always ready – grab and go for a quick trip out or wear confidently as part of your everyday carry.
Great for warm weather – wear with your shorts and t-shirt.
Not an either/or – Clipdraw will fit with your traditional style holster. You will not need to remove your Clipdraw when carrying with other holsters.

Special Tempered Spring Steel Clip with High Quality Powder Coat Finish
Provides Flex and Memory for use over any sized belt then returns to original retention point. Finish prevents any scratching or abrasions to your pistol.
Replacement Slide Cover Plate made from Machine Aluminum with 2 Pre-Drilled Screw Holes
4 Screws, 4 Washers (only 2 are required, 2 are extra) and Allen Wrench for installation of clip to the replacement slide cover plate.
Each Clipdraw is made to the exact specs of your pistol!

Add a custom engraving to your Springfield HELLCAT Pistol Clipdraw!
Perfect gift for family, friends or yourself
Names, Nicknames, Dates, 2nd Amendment, Military and Law Enforcement Messages – Anything that’s important to you!
Quick Shipping – Engraving does not slow down your shipment timeframe

Separate slide from the frame
Remove the barrel assembly
HELLCAT: Using a pin punch or screwdriver – press down on black spacer sleeve with spring located in the slide of your gun and press towards the muzzle.
Then, with your other hand – carefully remove the slide cover plate. Be Careful! Components are spring loaded.
Install Clipdraw replacement slide cover plate by pressing on black plastic insert at back end of slide while simultaneously inserting slide cover plate into position. Push in on black spring (upper right corner of rear slide cover) as your are installing.
Mount the clip on either side using screws, washers and allen wrench provided.

Kydex Trigger Guard made specifically to fit your Springfield HELLCAT PRO Pistol.
Provides trigger protection when your pistol is ‘holstered’
Guard removes itself when pistol is drawn – no extra steps for the shooter!
Does NOT fit with front mounted lasers.
High Quality Kydex does not crack or break
Set the cord length to your appropriate draw.

HCTS fits Springfield HELLCAT

Snap trigger guard onto pistol over your entire trigger housing area
Loop cord around your belt or belt loop
Once drawn from concealed position, the cord will come to full length and kydex guard will remove itself from your pistol.
Pistol is ready for operation.

TRIGGER SHEATH – SPRINGFIELD HELLCAT PRO